David Hopper

I ran into this after changing pool settings and thought the machine was the problem. In my case the miner was fine, but the network path was unstable and the shares started coming through only after ...

For anyone still troubleshooting this, the most useful sequence I found was: confirm the wallet and worker format first, then verify the stratum target, then check miner logs, then look at temperature...

I ran into this after changing pool settings and thought the machine was the problem. In my case the miner was fine, but the network path was unstable and the shares started coming through only after ...

This is more common than people think, especially with new firmware or rushed setup changes.

I agree with the general advice here, but I would also check the wallet address, worker naming, and temperature at the same time. A lot of people focus only on the connection and miss something obviou...

Thanks for posting this. I was trying to figure out the same thing today.

This kind of thread is useful because the same symptom can come from different causes. The best replies are the ones that show the exact setup, the tests performed, and what finally changed the result...

Good point. A lot of beginners skip that check and then waste hours troubleshooting.

This kind of thread is useful because the same symptom can come from different causes. The best replies are the ones that show the exact setup, the tests performed, and what finally changed the result...

For anyone still troubleshooting this, the most useful sequence I found was: confirm the wallet and worker format first, then verify the stratum target, then check miner logs, then look at temperature...

I like this topic because it gets closer to how mining actually works in the real world. A lot of people read generic advice and assume the answer is always hardware or always pool-side, but in practi...

Good point. A lot of beginners skip that check and then waste hours troubleshooting.