I agree with the general advice here, but I would also check the wallet address, worker naming, and temperature at the same time. A lot of people focu...

What helped me most was writing down the exact symptoms before changing anything. Once I compared the dashboard, local logs, and power behavior togeth...

I agree with the general advice here, but I would also check the wallet address, worker naming, and temperature at the same time. A lot of people focu...

This is more common than people think, especially with new firmware or rushed setup changes.

Thanks for posting this. I was trying to figure out the same thing today.

I agree with the general advice here, but I would also check the wallet address, worker naming, and temperature at the same time. A lot of people focu...

Good point. A lot of beginners skip that check and then waste hours troubleshooting.

This kind of thread is useful because the same symptom can come from different causes. The best replies are the ones that show the exact setup, the te...

I agree with the general advice here, but I would also check the wallet address, worker naming, and temperature at the same time. A lot of people focu...

I agree with the general advice here, but I would also check the wallet address, worker naming, and temperature at the same time. A lot of people focu...

I had a similar situation on a smaller setup and the lesson for me was not to assume profitability or stability from one short test window. Watching b...

This is more common than people think, especially with new firmware or rushed setup changes.

I ran into this after changing pool settings and thought the machine was the problem. In my case the miner was fine, but the network path was unstable...