This is more common than people think, especially with new firmware or rushed setup changes.

I had something similar happen and the fix was much simpler than I expected.

Good point. A lot of beginners skip that check and then waste hours troubleshooting.

I agree with the general advice here, but I would also check the wallet address, worker naming, and temperature at the same time. A lot of people focu...

I had a similar situation on a smaller setup and the lesson for me was not to assume profitability or stability from one short test window. Watching b...

I agree with the general advice here, but I would also check the wallet address, worker naming, and temperature at the same time. A lot of people focu...

I like this topic because it gets closer to how mining actually works in the real world. A lot of people read generic advice and assume the answer is ...

I agree with the general advice here, but I would also check the wallet address, worker naming, and temperature at the same time. A lot of people focu...

I agree with the general advice here, but I would also check the wallet address, worker naming, and temperature at the same time. A lot of people focu...

For anyone still troubleshooting this, the most useful sequence I found was: confirm the wallet and worker format first, then verify the stratum targe...

I agree with the general advice here, but I would also check the wallet address, worker naming, and temperature at the same time. A lot of people focu...

I had a similar situation on a smaller setup and the lesson for me was not to assume profitability or stability from one short test window. Watching b...

I ran into this after changing pool settings and thought the machine was the problem. In my case the miner was fine, but the network path was unstable...