Ed
@eazaraev1
Registered
Estimable Member
Joined: September 24, 2025 11:15 AM
Last seen: September 24, 2025 12:58 PM
Topics: 0 / Replies: 139
Reply

Same issue here. The miner looked connected, but it turned out the worker format was wrong.

4 months ago
Reply

I had a similar situation on a smaller setup and the lesson for me was not to assume profitability or stability from one short test window. Watching b...

4 months ago
Forum
Reply

I had a similar situation on a smaller setup and the lesson for me was not to assume profitability or stability from one short test window. Watching b...

4 months ago
Forum
Reply

Good point. A lot of beginners skip that check and then waste hours troubleshooting.

4 months ago
Reply

I had something similar happen and the fix was much simpler than I expected.

4 months ago
Reply

My experience has been that many mining problems are not one big failure but several small issues at once. A setup can look almost correct while still...

4 months ago
Forum
Reply

I agree with the general advice here, but I would also check the wallet address, worker naming, and temperature at the same time. A lot of people focu...

4 months ago
Reply

I ran into this after changing pool settings and thought the machine was the problem. In my case the miner was fine, but the network path was unstable...

4 months ago
Forum
Reply

I had a similar situation on a smaller setup and the lesson for me was not to assume profitability or stability from one short test window. Watching b...

4 months ago
Reply

My experience has been that many mining problems are not one big failure but several small issues at once. A setup can look almost correct while still...

4 months ago
Reply

This is more common than people think, especially with new firmware or rushed setup changes.

4 months ago
Reply

What helped me most was writing down the exact symptoms before changing anything. Once I compared the dashboard, local logs, and power behavior togeth...

4 months ago
Reply

For anyone still troubleshooting this, the most useful sequence I found was: confirm the wallet and worker format first, then verify the stratum targe...

4 months ago
Page 9 / 10