I ran into this after changing pool settings and thought the machine was the problem. In my case the miner was fine, but the network path was unstable...

My experience has been that many mining problems are not one big failure but several small issues at once. A setup can look almost correct while still...

I agree with the general advice here, but I would also check the wallet address, worker naming, and temperature at the same time. A lot of people focu...

I ran into this after changing pool settings and thought the machine was the problem. In my case the miner was fine, but the network path was unstable...

Same issue here. The miner looked connected, but it turned out the worker format was wrong.

Good point. A lot of beginners skip that check and then waste hours troubleshooting.

Same issue here. The miner looked connected, but it turned out the worker format was wrong.

I agree with the general advice here, but I would also check the wallet address, worker naming, and temperature at the same time. A lot of people focu...

I agree with the general advice here, but I would also check the wallet address, worker naming, and temperature at the same time. A lot of people focu...

I think the key here is testing one change at a time instead of changing everything at once.

I had a similar situation on a smaller setup and the lesson for me was not to assume profitability or stability from one short test window. Watching b...

For anyone still troubleshooting this, the most useful sequence I found was: confirm the wallet and worker format first, then verify the stratum targe...

What helped me most was writing down the exact symptoms before changing anything. Once I compared the dashboard, local logs, and power behavior togeth...