I had something similar happen and the fix was much simpler than I expected.

I ran into this after changing pool settings and thought the machine was the problem. In my case the miner was fine, but the network path was unstable...

This is more common than people think, especially with new firmware or rushed setup changes.

I agree with the general advice here, but I would also check the wallet address, worker naming, and temperature at the same time. A lot of people focu...

I had something similar happen and the fix was much simpler than I expected.

I think the key here is testing one change at a time instead of changing everything at once.

For anyone still troubleshooting this, the most useful sequence I found was: confirm the wallet and worker format first, then verify the stratum targe...

What helped me most was writing down the exact symptoms before changing anything. Once I compared the dashboard, local logs, and power behavior togeth...

I think the key here is testing one change at a time instead of changing everything at once.

Thanks for posting this. I was trying to figure out the same thing today.

This kind of thread is useful because the same symptom can come from different causes. The best replies are the ones that show the exact setup, the te...

Good point. A lot of beginners skip that check and then waste hours troubleshooting.

Good point. A lot of beginners skip that check and then waste hours troubleshooting.

I had a similar situation on a smaller setup and the lesson for me was not to assume profitability or stability from one short test window. Watching b...