mccdxx
@mccdxx
Registered
Estimable Member
Joined: October 3, 2025 5:20 AM
Last seen: March 20, 2026 4:25 AM
Topics: 0 / Replies: 132
Reply

This kind of thread is useful because the same symptom can come from different causes. The best replies are the ones that show the exact setup, the te...

4 days ago
Forum
Reply

I had a similar situation on a smaller setup and the lesson for me was not to assume profitability or stability from one short test window. Watching b...

4 days ago
Forum
Reply

This kind of thread is useful because the same symptom can come from different causes. The best replies are the ones that show the exact setup, the te...

7 days ago
Reply

This is more common than people think, especially with new firmware or rushed setup changes.

1 week ago
Reply

I had a similar situation on a smaller setup and the lesson for me was not to assume profitability or stability from one short test window. Watching b...

1 week ago
Forum
Reply

I ran into this after changing pool settings and thought the machine was the problem. In my case the miner was fine, but the network path was unstable...

2 weeks ago
Forum
Reply

I like this topic because it gets closer to how mining actually works in the real world. A lot of people read generic advice and assume the answer is ...

2 weeks ago
Forum
Reply

What helped me most was writing down the exact symptoms before changing anything. Once I compared the dashboard, local logs, and power behavior togeth...

2 weeks ago
Reply

For anyone still troubleshooting this, the most useful sequence I found was: confirm the wallet and worker format first, then verify the stratum targe...

2 weeks ago
Reply

I agree with the general advice here, but I would also check the wallet address, worker naming, and temperature at the same time. A lot of people focu...

2 weeks ago
Forum
Reply

For anyone still troubleshooting this, the most useful sequence I found was: confirm the wallet and worker format first, then verify the stratum targe...

2 weeks ago
Forum
Reply

What helped me most was writing down the exact symptoms before changing anything. Once I compared the dashboard, local logs, and power behavior togeth...

2 weeks ago
Reply

Same issue here. The miner looked connected, but it turned out the worker format was wrong.

2 weeks ago
Forum
Reply

Good point. A lot of beginners skip that check and then waste hours troubleshooting.

3 weeks ago
Forum
Page 1 / 9