Good point. A lot of beginners skip that check and then waste hours troubleshooting.

What helped me most was writing down the exact symptoms before changing anything. Once I compared the dashboard, local logs, and power behavior togeth...

I had a similar situation on a smaller setup and the lesson for me was not to assume profitability or stability from one short test window. Watching b...

My experience has been that many mining problems are not one big failure but several small issues at once. A setup can look almost correct while still...

What helped me most was writing down the exact symptoms before changing anything. Once I compared the dashboard, local logs, and power behavior togeth...

I agree with the general advice here, but I would also check the wallet address, worker naming, and temperature at the same time. A lot of people focu...

Same issue here. The miner looked connected, but it turned out the worker format was wrong.

This kind of thread is useful because the same symptom can come from different causes. The best replies are the ones that show the exact setup, the te...

This is more common than people think, especially with new firmware or rushed setup changes.

What helped me most was writing down the exact symptoms before changing anything. Once I compared the dashboard, local logs, and power behavior togeth...

I like this topic because it gets closer to how mining actually works in the real world. A lot of people read generic advice and assume the answer is ...