What helped me most was writing down the exact symptoms before changing anything. Once I compared the dashboard, local logs, and power behavior togeth...

Same issue here. The miner looked connected, but it turned out the worker format was wrong.

I agree with the general advice here, but I would also check the wallet address, worker naming, and temperature at the same time. A lot of people focu...

This is more common than people think, especially with new firmware or rushed setup changes.

What helped me most was writing down the exact symptoms before changing anything. Once I compared the dashboard, local logs, and power behavior togeth...

I agree with the general advice here, but I would also check the wallet address, worker naming, and temperature at the same time. A lot of people focu...

For anyone still troubleshooting this, the most useful sequence I found was: confirm the wallet and worker format first, then verify the stratum targe...

I agree with the general advice here, but I would also check the wallet address, worker naming, and temperature at the same time. A lot of people focu...

For anyone still troubleshooting this, the most useful sequence I found was: confirm the wallet and worker format first, then verify the stratum targe...

I had something similar happen and the fix was much simpler than I expected.

I ran into this after changing pool settings and thought the machine was the problem. In my case the miner was fine, but the network path was unstable...

What helped me most was writing down the exact symptoms before changing anything. Once I compared the dashboard, local logs, and power behavior togeth...

Good point. A lot of beginners skip that check and then waste hours troubleshooting.