This discussion in 中文 (Chinese) is for beginners who are not ready to waste money. Good replies should explain what to learn first about power, heat, wallets, profitability, firmware, and realistic expectations.
For anyone still troubleshooting this, the most useful sequence I found was: confirm the wallet and worker format first, then verify the stratum target, then check miner logs, then look at temperature and uptime, and only after that start changing firmware or network settings. Doing it in a clean order saved me a lot of time because I stopped guessing and started isolating the real problem.
I agree with the general advice here, but I would also check the wallet address, worker naming, and temperature at the same time. A lot of people focus only on the connection and miss something obvious.
This kind of thread is useful because the same symptom can come from different causes. The best replies are the ones that show the exact setup, the tests performed, and what finally changed the result.
Thanks for posting this. I was trying to figure out the same thing today.
I think the most helpful answers here are the ones that explain what to check first, not just the final fix.
A practical comparison with real setup details would make this thread much more useful for future readers.
It helps a lot when people include what symptoms they saw, what they tested, and what actually changed the result.
This is a strong SEO-style topic because it matches the real questions miners keep asking again and again.
This is exactly the kind of question many new miners search for before they commit money or hardware.
