This thread is for broad beginner-friendly discussion in New Member Introductions. Please share the real questions new miners ask most often and the clear answers that help them avoid wasted time and bad assumptions.
Thanks for posting this. I was trying to figure out the same thing today.
For anyone still troubleshooting this, the most useful sequence I found was: confirm the wallet and worker format first, then verify the stratum target, then check miner logs, then look at temperature and uptime, and only after that start changing firmware or network settings. Doing it in a clean order saved me a lot of time because I stopped guessing and started isolating the real problem.
I agree with the general advice here, but I would also check the wallet address, worker naming, and temperature at the same time. A lot of people focus only on the connection and miss something obvious.
This kind of thread is useful because the same symptom can come from different causes. The best replies are the ones that show the exact setup, the tests performed, and what finally changed the result.
This is a useful topic because it gives miners the kind of practical detail that is often missing from generic advice.
I think discussions like this are strongest when people share exact setup details, what they tested, and what changed the result.
It also helps to separate theory from real-world miner experience, because many problems only show up under actual load and uptime conditions.
Threads like this can become excellent references when members explain the mistake, the symptoms, and the fix in a structured way.
I appreciate topics like this because they help newer miners avoid expensive errors and give experienced users a place to compare methods.
