h221321

I had a similar situation on a smaller setup and the lesson for me was not to assume profitability or stability from one short test window. Watching behavior over a longer period gave me a more realis...

I like this topic because it gets closer to how mining actually works in the real world. A lot of people read generic advice and assume the answer is always hardware or always pool-side, but in practi...

This kind of thread is useful because the same symptom can come from different causes. The best replies are the ones that show the exact setup, the tests performed, and what finally changed the result...

I had a similar situation on a smaller setup and the lesson for me was not to assume profitability or stability from one short test window. Watching behavior over a longer period gave me a more realis...

Thanks for posting this. I was trying to figure out the same thing today.

Same issue here. The miner looked connected, but it turned out the worker format was wrong.

I like this topic because it gets closer to how mining actually works in the real world. A lot of people read generic advice and assume the answer is always hardware or always pool-side, but in practi...

What helped me most was writing down the exact symptoms before changing anything. Once I compared the dashboard, local logs, and power behavior together, the real cause became much easier to spot.

What helped me most was writing down the exact symptoms before changing anything. Once I compared the dashboard, local logs, and power behavior together, the real cause became much easier to spot.

For anyone still troubleshooting this, the most useful sequence I found was: confirm the wallet and worker format first, then verify the stratum target, then check miner logs, then look at temperature...

I like this topic because it gets closer to how mining actually works in the real world. A lot of people read generic advice and assume the answer is always hardware or always pool-side, but in practi...