h221321

What helped me most was writing down the exact symptoms before changing anything. Once I compared the dashboard, local logs, and power behavior together, the real cause became much easier to spot.

For anyone still troubleshooting this, the most useful sequence I found was: confirm the wallet and worker format first, then verify the stratum target, then check miner logs, then look at temperature...

I like this topic because it gets closer to how mining actually works in the real world. A lot of people read generic advice and assume the answer is always hardware or always pool-side, but in practi...

This kind of thread is useful because the same symptom can come from different causes. The best replies are the ones that show the exact setup, the tests performed, and what finally changed the result...

My experience has been that many mining problems are not one big failure but several small issues at once. A setup can look almost correct while still underperforming because of heat, weak airflow, ba...

This is more common than people think, especially with new firmware or rushed setup changes.

I think the key here is testing one change at a time instead of changing everything at once.

This kind of thread is useful because the same symptom can come from different causes. The best replies are the ones that show the exact setup, the tests performed, and what finally changed the result...

This is more common than people think, especially with new firmware or rushed setup changes.

I agree with the general advice here, but I would also check the wallet address, worker naming, and temperature at the same time. A lot of people focus only on the connection and miss something obviou...

I had something similar happen and the fix was much simpler than I expected.

I think the key here is testing one change at a time instead of changing everything at once.