h221321

Same issue here. The miner looked connected, but it turned out the worker format was wrong.

I agree with the general advice here, but I would also check the wallet address, worker naming, and temperature at the same time. A lot of people focus only on the connection and miss something obviou...

This is more common than people think, especially with new firmware or rushed setup changes.

For anyone still troubleshooting this, the most useful sequence I found was: confirm the wallet and worker format first, then verify the stratum target, then check miner logs, then look at temperature...

I agree with the general advice here, but I would also check the wallet address, worker naming, and temperature at the same time. A lot of people focus only on the connection and miss something obviou...

This kind of thread is useful because the same symptom can come from different causes. The best replies are the ones that show the exact setup, the tests performed, and what finally changed the result...

I agree with the general advice here, but I would also check the wallet address, worker naming, and temperature at the same time. A lot of people focus only on the connection and miss something obviou...

What helped me most was writing down the exact symptoms before changing anything. Once I compared the dashboard, local logs, and power behavior together, the real cause became much easier to spot.

I ran into this after changing pool settings and thought the machine was the problem. In my case the miner was fine, but the network path was unstable and the shares started coming through only after ...

My experience has been that many mining problems are not one big failure but several small issues at once. A setup can look almost correct while still underperforming because of heat, weak airflow, ba...

My experience has been that many mining problems are not one big failure but several small issues at once. A setup can look almost correct while still underperforming because of heat, weak airflow, ba...

I ran into this after changing pool settings and thought the machine was the problem. In my case the miner was fine, but the network path was unstable and the shares started coming through only after ...

For anyone still troubleshooting this, the most useful sequence I found was: confirm the wallet and worker format first, then verify the stratum target, then check miner logs, then look at temperature...